CVT Scooter Belt
(2)
Banded Belt
(1)
To the right tightness
Belt inspection methods is very simple. First check the belt tension, select the longest unsupported span of the middle of the Drive Belt to exert moderate pressure with the thumb, if the amount of reduction belt 10 mm or so, then that just the right belt tension. If the belt tension is too large, or too loose, it could result in sliding gear, transmission is incomplete. The transmission belt adjusted too tight, it will makes the belt easy to tensile deformation at the same time will also speed up the pulley and bearing wear. To this end, should be related to the adjustment screw loose nuts or bolts to adjust the belt tension to the best condition.
Note that the wear
Repair Master told reporters at the same time, owners in daily inspection should also pay special attention to wear belts. Because if the belt were badly worn belt and pulley will cause sharp drop in the contact area. Then as long as the pressure forced a belt, belt pulley on the deep sink into the tank.
In addition, if the surface cracks found belt phenomena such as cracks and spalling, or slipping belt appears sound, said belt may be broken, must be replaced immediately. If not promptly replaced, belts in a moving way, once broken, the vehicle will not be running properly.
